Start by gearing up. You will want to wear old shoes that you don’t care about, and gloves if you’re going to be handling the stripped paint. This stripper is no joke, it burns if you get it on your skin.
you will need:
Scrub Brush (or Wire Brush).
Spirits, Turpentine, or Paint Stripper.
When you set out to remove paint from concrete, the first thing to do is clean the surface of the concrete thoroughly.
Prepare a solution of soap and water, or better yet, diluted trisodium phosphate (TSP)—in which case, be sure to wear gloves.
sweep or wipe off the concrete, removing as much loose dust, dirt, and debris as possible.
Now proceed to work the soapy water or TSP into the concrete by means of a long-handled brush.
Rinse the area afterward, allowing one to three hours for the surface to dry.
If some of the paint has already begun to chip or peel, scrape it away with a putty knife.
Not sure which type of paint is on the concrete? If you’re uncertain, your best bet is to opt for an oil-based paint stripper.
Once you’ve covered the concrete with a generous layer of paint stripper, let it sit for six to eight hours.
During that time, a chemical reaction will take place, the magical result of which is the removal of paint.
Remember that if you’re working with paint stripper, it’s imperative that you wear the appropriate protective gear a respirator (or at minimum, a dust mask), long sleeves, and good pair of rubber gloves.
Pour the stripper onto the ground and roll it out with a paint roller. The layer should be thick. If it’s too thin you’ll have to go back with a second layer.
Let the stripper sit on the paint for 20-25 minutes. As it activates and loosens the paint.
you will see it start to bubble and release itself from the concrete. If you’re lucky like we were, you might even discover hidden dinosaur tracks underneath a few of the layers.
Scrape. Use your floor scraper to scrape off the bubbled up paint. We found that it was best to scrape it all into a large pile and then shovel it into old boxes.
Once you’ve scraped all of the paint off of the concrete floors, use a bucket of soapy water and a large push broom to sweep up any remaining chunks of paint and to get the stripper residue off of the concrete.
Let the concrete dry for 24-48 hours before moving on to the next step of prep, or tile.
You need to mix the paint remover with the ground clay and try to make a thick paste.
You will not need a lot of clay if the used stripper will be thick steadiness.
The porous stuff would be very helpful in soaking as well as paint lifting from the surface of concrete, which will make the stubborn paint very easy to be scraped off afterward.
Scrub The Affected Area. Now, you must take some scrubbing powder and apply it to the paint spot.
Now, take your hard brush and need to rub tough on the spot to remove the tough stains off.
You need to rinse off the scrubbing powder after some time and continue rubbing the area with the brush to take out the residual paint particles.
If the above method does not work for you, then repeat the whole process. If you can’t do it yourself then hire and professional blaster will be the best option for you.
DIY| Best Paint Edger For A Beautiful Room | DIY Projects Start by thinking about how you want the finished project to look and remember
DIY How to Build a Porch Swing | DIY Homemade A porch swing symbolizes one thing: leisure. That’s why it became such a popular fixture
DIY Plumbing – choose a good plumber | DIY Projects Everyone loves a deal, but the cheapest bidder is not always the best. How are
DIY | Uses for Baking Soda in Laundry Did you know that you actually should be cleaning your washing machine? I mean, its whole job